0
0
This site is not for children. Are you over 18?
Everyones favorite, the MP5, but nearly entirely printable
The MP22 and its variants are nearly entirely 3d printed clones of H&K’s MP5. The documentation is thorough, and there are a ton of variants available and included in the pack. This is an advanced build, with nearly 50 hard parts you will need to buy in addition to the printed plastic pieces. Fortunately, it is well documented, with an 18 page full color PDF that is very detailed.
There are a few inaccuracies in the BOM in the build documentation. Updated BOM with links can be found here.
Hand drill
1/16” drill bit
1/8” drill bit
1/4” drill bit
15/64” drill bit
Files
Two part epoxy
Kinetic sand
Propane torch
The Print-a-22 shop is only remaining open while we process pending orders. For all future purchases, please head over to FTW-Arms.
Already placed an order on Print-a-22? No action is needed — we are still processing pending orders.
One Response
Some of the pictures are difficult to make out. Brighter with better contrast would make for better results. Just a thought.